The steps are equally follows:
Each brace of wires to the pins that volition hold out linked to the number:
- 1-3 to the HDD LED cable
- 2-4 To the POWER LED cable
- 5-7 To RESET SW cable
- 6-8 To Cable POWER SW
Then set each pin:
- 2 [C] [D] [D +] [G] [] pairs of pins [VCC] [USB2-] [USB2 +] [GND] [empty]
- 1 [C] [D] [D +] [G] tide pivot [VCC] [USB1-] [USB1 +] [GND]
- In the get-go event that is linked solely MIC, MIC-POWER, AUD-OUT-R, AUD-OUT-L, in addition to GND.
- In the minute illustration in that place is the add-on of which is connected at the get-go event that in that place are two GND
- In the 3rd illustration to a greater extent than connected but in that place is solely i GND in addition to additions to the backout-R in addition to backout-L
Good Luck....
Labels: Tips
